Posted by Leroy on May 05, 2013 at 07:56:01 from (69.88.205.38):
In Reply to: Re: people mover posted by Kent Petersen on May 04, 2013 at 12:18:26:
That outfit is no good, way too high up. You need to start out with a gear that the bolsters are low as about straight with the hubs then the sills as normal but put the cross pieces underneeth the sills and put the floor on them that are not more than 18" off the ground the sills should be the height of a seat and have the seats even with the tops of the sills. And a 2' high back rest. You need only one hinged steep that will raise if hits the ground that way but make sure it is a sollid non slip steep so that canes and crutches can safly use it. No expanded mesh for that cane tip to get cought in. And for those people that need the transportation they cannot get on a wagon that it as heigh as the one pictured. And that would also help the young families with small kids and a stroller. Put the steps on the back and with a closed gate whenever it is moving and always have a rider on the back to give comands and handle that gate. That way no body trying to get on or off a moving unit. Good idea would be a speaker system for the gate operator to be able to talk to the tractor operator as a lot of the tractors are too noisy to be able to be heard over and a lot of times the drivers are older with hearing problems so help them as much as possible and with that you will get more people to help with the driving. And therefore be safer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Mud Daubers and the Old John Deere - by Jon Zehnder. I have a 1941, John Deere Model A tractor I have owned for about a year and a half. This is my first (in case my wife reads this, "FIRST") tractor and it has been a learning experience. After considerable advise and assistance from local tractor nuts and the forums of Yesterday�s Tractors, I had finally got it running pretty well. I have tuned it up, overhauled the carburetor, installed a borrowed, rebuilt magneto, installed a new Power-Trol, patched the radiator, installed new front wheels a
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
