Posted by fixerupper on May 04, 2013 at 21:02:29 from (100.42.82.30):
In Reply to: Rotator Cuff posted by Icuby on May 04, 2013 at 12:32:23:
Had a rotator cuff repair with one reattachment three or four years ago and everything is mostly fine now. I have full range, though some scar tissue does make it thump some when I really rotate it but the thumping doesn't hurt. When the knee conked out on me last summer I did find out that shoulder hurts when I push down on a crutch but that's the only time. When I was at the orthopaedists office last summer I was reading a chart on the wall about all the surgeries they do and what to expect for recovery time. I was surprised to find out from reading that chart, that rotator cuff surgery has a recovery period that is twice as long as the recovery period for complete shoulder replacement. For rotator cuff repair, there should be no shoulder movement for two or three weeks, I forget on that one. For shoulder replacement they want you to start movement and exersize almost immediately. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
