Posted by big jt on May 04, 2013 at 09:12:13 from (206.72.54.246):
In Reply to: Char-lyn posted by tomturkey on May 04, 2013 at 07:37:55:
Yep I have done it a few times.
One poster mentioned the timing. The sheet that comes with the kit discusses that if I remember.
The other issue I don't see mentioned you need a deep 12 point socket to take out the bolts that hold the motor together. It is either 1/4 or 5/16 depending on your motor. This is a tool truck type item as most sets if they even go down that small go to 6 point below 3/8. Socket does NOT come with the kit.
Posting a link for Snap On's 1/4 socket. I was suprised at the price being below $5.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
