Typical Class A Generators, 2 or 3 brush, have an external FLD post. It takes a connection from there to a ground source, via a Voltage Regulator or Low/High light switch manual control, to complete the Field circuit. The beginning of the field circuit (first winding) begins at the third brush,,,,,,,,to and through the first coil,,,,,,,to and through the second coil,,,,,,,,to the FLD post,,,,,,,to ground via the VR or switch
Some Class B Generators Ground the field internally and field current is regulated by varying the voltage on its input.
In all my years as a used tractor dealer and many many makes n models of Generators I had to repair grrrrrrrrrr 2 or 3 brush gennys had external Field posts.
Of course, never say never, since there are different types and brands of gennys out there some 3 brush may use an internal ground and NOT have any FLD post, but of the tons I owned and worked on over the years (all different brands)they sure did.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
