Posted by MattE on May 03, 2013 at 06:53:19 from (98.103.14.114):
In Reply to: Tree Cuttin Experts posted by Banditfarmer on May 02, 2013 at 18:54:15:
Lot of good ways to get killed there. Mainly by listening to the advise on this board.
Since the tree is going to go into the field regardless what you need to avoid is 1) the limb breaking and driving itself into the field they can then be a bear to cut off and pull out 2) and the big one: is the tree hollow. With that much weight and lean it could "barber chair" or split several feet up and swing back at the sawyer.
I have attached a picture of how I would cut it. By leaving a heavier hinge on one side it will cause the tree to twist slightly on the stump as it falls.
It will spin the opposite direction of the arrow in the picture. With that overhanging weight it won't spin much, but enough so that limb lays down rather than hitting direct and bouncing the but or embedding itself in the ground.
I would also recommend bore cutting your back cut to take some of the risk away from it splitting it also makes sure you are on the side of the tree when you finish the back cut especially if your bar is not long enough to completely pierce the tree.
It does not look too bad, but I'm not there in person. I've cut professionally for twenty some years. If it scares you have a pro do it. Otherwise just make sure you have a clear escape path, and a saw with enough nuts and bar to get it and get out with out having to screw around. Heavy leaners are second only to wind damage as killers in my book.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
