Posted by RBnSC on April 20, 2013 at 06:28:33 from (24.236.77.56):
In Reply to: funny re-bar posted by greg k on April 19, 2013 at 14:58:05:
I have busted up lots of concrete but have never found anything that cool for rebar. Years ago did a job for the City of Charleston clearing out underground obstructions so piling could be driven for a parking garage downtown. We had been there for several weeks on "time and materials".It was killing the engineer over the job. One day He comes by the job and I tell him all we have left to do is get rid of this last chunk of concrete and we will be finished. This thing was 6ft X 6ft X 8ft thought to be a steam engine mount. We had dug it up and rolled it out of the hole just sitting out on the job. All we were going to do was slide it onto the lowboy and haul it to the dump if He would have been 30 minutes later it would have been gone. He sees it and says leave it alone they had guys with jack hammers and they would take care of it. So I asked him "are you sure?" He says yes yall are done here. OK. A couple of weeks later I get a call could I take my big loader and roll the chunk of concrete over. I went there and they had rounded the edges off the block off. It was laced with railroad track for reinforcement. In all that time they had hardly made a dent in it. Ron
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
