Posted by notjustair on April 15, 2013 at 18:39:48 from (174.230.128.164):
In Reply to: farmall m,..again posted by ohiojim on April 15, 2013 at 04:58:06:
I have a socket set that has sizes up to 4 1/2 inches. One of those sockets was the perfect size to push out the sleeves. I placed the socket on a 2 inch piece of pipe and used a 3 ton floor jack from the bottom side (crank still in). They came right out. That first "pop" when they start moving will about make you wet your pants, but it works good. Had them all out in about 20 minutes. I was too scared to weld a bead on them.
I put a brooder heat lamp down each cylinder and put the new sleeves in the freezer overnight. I did them one by one and they only needed a couple taps on a 2x4 to get the last inch or so. It was very anti-climactic.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Collection of a Lifetime - by Sherry Schaefer. The larest gathering of orphan tractors ever assembled by one collector will be auctioned off on May 15 in Rock Island, IL. Ed Spiess was a well known tractor buff who spent most of his time dreaming of rare and unknown tractors. His background as an agricultural engineer sparked his interest in the unique attributes of the models built from 1939-1959.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
