Posted by Janicholson on March 26, 2013 at 18:02:31 from (74.60.94.18):
In Reply to: Plowing posted by David G on March 26, 2013 at 16:20:59:
Start with a back furrow, go a measured 70ft in from one side (measure both ends and put a white flag on a branch or post). Adjust the plow so it turns a pretty good set of furrows with both wheels on the level. Proceed from about 20 ft from one end to no closer than 20 ft from the other, in a straight line keeping the flag in sight. Turn around to the right and plow the opposite direction, with the right wheel just edging onto the turned earth from the other set of furrows. When you get to the starting end, turn into the furrow, the right wheel will be in the furrow. Stop and adjust the plow to level with the wheel in the furrow. Experiment to get it so each bottom is making equal depth cuts. (may require some digging to make sure. Continue around and around this "land" (what it is called) till you get as close to the fence as comfortable. Measure from the last furrow to the next 70 foot back furrow. and repeat the process. When you finish this "land" you will have a "dead furrow" where two furrows are in the same place. No issue, it will be disked somewhat smooth. Repeat until you get to the far side of the field. Make the last "land" 1/2 the distance to the side fence so that it will finish off the field. Then do the headlands. Plow with the earth turning toward the field. Drive back to the other end of the same headland to keep the single furrow on the outside toward the fence. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
