Posted by Patsdeere on March 10, 2013 at 20:29:47 from (69.181.81.182):
I have an american bosch mag on a hercules IXA motor in a 4 wheel silver king. I finally got it fired up today after setting a couple of years since I got it. Had to do the regular stuff (carb clean, tank clean, bowl clean/gasket replace) and clean the plugs.
After it had fired up and ran for a couple of minutes I heard a noise, sort of like rrrrrrrrrrrrrrrrrrrrrrr. I isolated the noise to the mag (could feel little vibration in the mag housing when it was making the noise). It will do it for 30 seconds and then not for a minute or two and then do it again. I looked for a place where I could add a little lube to the mag, but didn't see one. Mag looks nice and clean, no corrsion, so I am guess it has been rebuilt at some point in its life. Any ideas on what might be making the noise and how to fix it?
Other than the noise, that thing purred. It was like it hadn't been sitting for 10 years. So great to finally have it running.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tinker�s Guide to Manifold Repairs - by Curtis Von Fange. A common characteristic of keeping older equipment is that some parts to make repairs can be extremely difficult to locate. For example, finding a replacement for a cracked intake or exhaust manifold on a unique tractor or odd brand can be a frustrating and downright impossible mission. So, what is an alternative solution to scraping out that �one of a kind� piece of history? First, decide if you are one to try a repair yourself or have someone else do it. If you are uncomfortable about
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
