It was 5 weeks ago yesterday that I had rotator cuff surgery on my left shoulder. Also some bone spurs the surgeon ground down and trimmed up the end of the torn tendon and then pinned it in place with some sort of plastic straps. It's amazing what they can do through those small incisions. I was cut in 3 places, 1 incision was about 3/4" and the other 2 were only about 1/2" long. Started therapy yesterday. There was some pain when doing the stretching excercises but afterward it felt good to just be putting the arm and shoulder to use. Overall I have a littles less pain than I had before the operation, but my degree of mobility is still about the same as before I had surgery. Hopefully that will improve as therapy progresses. I'm thinking it will be at least 4 months until I get back close to normal. In the mean time bored stiff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
