Posted by DoubleR on March 02, 2013 at 07:20:33 from (198.105.230.174):
In Reply to: Re: 3 point tiller posted by pete black on March 02, 2013 at 06:31:08:
Sounds like you already got allot of good advice. I run a 66 inch tiller on a 30 hp hydro and a 40 hp. 8speed. Depends on which tractor is available at the time. The 40 hp. has no problem in about anything I encounter. The hydro does good also except it does have its hands full in new ground that has not been worked in a while. But it will still get the job done. I have been through three sets of tines on my tiller so it does get used allot. I think 30 hp on a 60 inch tiller would be a good fit especially if its a hydro. I don't think my tiller is built any better than that TSC model but its held up good for me. I have looked at allot of tillers and allot of them look like they were manufactured by the same place only difference is the color of paint. Most of them use the same tines. I too have a Troy-built tiller which I don't use much anymore. The 3pt tiller will do allot nicer job and is a allot quicker.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
