Posted by flying belgian on February 28, 2013 at 19:11:17 from (98.132.233.146):
In Reply to: JD 2440 CAB posted by Mike Schill on February 28, 2013 at 17:53:36:
Both the Year-around and the Hiniker were made in Mankato Mn. I worked in research and development for Hiniker. They are very similar and both start out with a basic cab for every tractor make and model. The only thing different is the mounts and floor plates and cowl filler plates. Hiniker never sold many mounts for the 2440 so I doubt you will find a used set. I would bet year around did not either. So go ahead and buy the year around from the 4520 then hang it from a shed rafter or tree limb and take the fenders off your 2440. drive the tractor under the hanging cab and let it down into position. Now build some mounts out of tubing from axle housing up to hinge point on back of cab. then build some mounts from tractor frame rails up to front mounting points on cab which is at front corners under doors. Now take some cardboard and make patterns of some floor plates and filler plates that you need around cowl. Take your patterns to a fab. shop and have them make the plates. This may sound overwhelming to you but you can do it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
