Years ago Dad pulled permits and did a remodel on our old house. That turned into nothing but a PITA for him and he wound up all but running one inspector off because he was demanding to see something another inspector had already signed off on and had been finished over. Needless to say he never saw it. Some years later Dad decided to build himself a shop. About halfway through an inspector pulled up and came walking toward him running his mouth about it not being permitted, etc. He was very nicely told to get his a$$ back in his car and to hit the end of the drive as quickly as he could and to never set foot back on what was private property. That was something like 35 years ago and Dad never heard anything else from them.
My point here is don't say anything, and just let it drop on your end. As old as the house is, and as long ago as the work was done, unless you admit to them that you did the work unpermitted it's up to them to prove that anything was done. I doubt seriously they can prove anything without dated pictures, etc and as such anything said would be your word against theirs...and their word would be worth very little unless 'they' were around that long ago to see it themselves, and even then it's a he said, he said situation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
