Posted by JD Seller on February 12, 2013 at 01:54:02 from (208.126.196.144):
In Reply to: OT Have you heard?? posted by John B. on February 11, 2013 at 09:25:35:
I do not mind if a kid does not have very good penmanship but they should be at least able to read cursive writing. One of my Grand kids has not been taught cursive in school. She could not hand out the Christmas gifts because she could not read the name tags.
Also the real danger/issue with not knowing how to read cursive is that most of the founding documents of this great nation where written in cursive. So if we raise a bunch of illiterate students that can not read those important documents do you really think they will under stand them???
So I guess I am old school. I write my load lists in cursive. So I guess if the driver can not read them he will just get fired.
Side bar to Dan the teacher below. Modern schools have the time to show my kids/grand kids how to use a condom but not to read/write cursive. Which is worse for our society???
So they can't read cursive but they can put a condom on and then take a picture of it an then they can post on their face book page with their fancy computer.
I know of two different human resource people that give cursive reading tests to applicants. Any that can't read/write cursive are passed by. Those companies both are heavy into computers. They both say that if the person does not know cursive they more than likely don't know a bunch of other needed job skills. So the cursive test just helps them thin the list down.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.