Posted by Ralphwd45 on February 07, 2013 at 22:40:44 from (66.243.213.196):
I wanted to put a new roof on one of my old hogsheds. It is 14x14, open on the front, and doesnt have much pitch, maybe 12" in 14'The old rolled roofing had blown off last winter, and exposed the OSB sheeting. The sheeting has deterioated from the rains, and swollen. ANYWAY- I went to my local lumberyard this morning, to buy materials.I asked for 1/2" OSB for sheeting, and was told that 7/16", was what had replaced 1/2" CDX, as sheeting, and that they didn't carry 1/2" OSB.I asked their price on 1/2" CDX, and it was only $2.00 a sheet higher, so I asked for 8 sheets of 1/2'CDX. I told the guy that I wanted 5 lb's of #8 common nails. He went to his bulk lazy susan bins, and started filling a paper sack, I had drifted along behind him, and saw what looked to me like #6 nails being put in the sack.I stopped him and repeated that I wanted #8's. He said that was what he was putting in the bag. (I am not going to repeat our arguing here) but I showed him the diameter of a #6 and the diameter of his suposedly #8's were the same size visually, only the length was longer. I then pointed to the size nail that I wanted, and he called it #12. It was the proper looking diameter, but was about 1/2' longer than I liked.I settled for # 12's, and took my materials and left pizzed. 2"x6"x14' runs 1 1/2"x5 1/2"x 14' long. OSB sheeting is 1/16" under 1/2", and now the diameter of nails has shrunk, OR is it just me!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.