Posted by donjr on February 06, 2013 at 20:31:09 from (72.71.177.201):
On my tractors, that is. But I've had a clock in the living room that occasionally decides to quit working. And it's a wall clock wiyh a New England clockwork in it. So, it takes about an afternoon to tear it apart and clean the bearings to get it to work again. But this time, i tried something just a bit different. I have noticed that ether will cut grease and dirt off parts quicker than anything else I have seen short of dynamite. So, I tried a shot into the back end- not a lot, just a couple of quick shots. Hung it back up, levelled it, and it's ticking up a storm. And faster than any other method I've used. The new ether has a touch of oil in it, too, so I'll try this without further lubrication on the bearings. Now, Mom's actually happy that I cleaned her clock....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
