Posted by Diydave on January 31, 2013 at 10:24:45 from (96.244.162.208):
In Reply to: POWDER WEDGE posted by kenben on January 31, 2013 at 08:25:03:
The way to do it is to take a chainsaw, and stick the nose into the log, near the bottom of the log, on the side of the log. You want to excavate a pocket, bigger at the base of the pocket, than at the top. You really don't need a lot of powder, but you want a fast burning powder, relatively fine grade. I have seen Hercules Bulls eye powder, and black powder fffg used for this. You put the powder into a tinfoil packet, and slide a cannon fuse into it. Then you slide the flat packet into the pocket you excavated with the chainsaw. You hammer in a a tapered wooden wedge in being sure not to mash up the foil packet, or the fuse. The only reason for the foil is to keep the powder from getting wet. As it says on the firecracker package, light fuse, and walk away. Properly done, the log moves little more than apart. don't be a jacka ss and end up on youtube!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
