Stubie, I have a 750 drill and have run it for several years. I've pulled it with a '64 4020, a '71 4020 with cab and a 4440. All pulled the drill just fine. Obviously, the 4440 pulls it the best and the two-speed is handy on the ends. As important as horsepower is weight. This drill is very heavy. It will weigh somewhere in the neighborhood of 13,000 lbs. full. You want a tractor with at least that much weight pulling it. Otherwise, when you turn at the bottom of a hill the drill could scoot you around. The early 4020 was a little light for the drill, the late 4020 was adequate and the 4440 is better. Hope this helps. Mike
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
