Nope, it's a Tree w/ Dynapath control. I had a coworker make a program for the threadmill as I'm a little rusty at Mastercam and would have been there for 2 days trying to figure it out, seeing as I've never programmed a threadmill before.
We program pretty much everything offline in our shop, so I don't do much at the controls anymore either. Still do some edits, but most are easier to go back to cam and have them change it in a few clicks of a mouse
Lots of 3D parts, and more than 2 peices that share a part number are few and far between.
Overall, a great shop to work. I run 2 of the bigger VMC's in the shop (the Tree w/ 25x50 table, and a Takumi with a 40 x 70 table), do most of the welding (Miller 200, 350P, and a Lincoln Tig Welder), and a few other things. Also have full access to a 36" Blanchard grinder, a fully automatic surface grinder. Great shop with a great owner who doesn't mind guys working on personal projects- and I've done my fair share and then some... I've done some fairly large projects in the shop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
