Tractor Talk Discussion Board |
Re: Starting a rebuilt motor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by glennster on June 07, 2007 at 07:48:19 from (76.224.16.173):
In Reply to: Starting a rebuilt motor posted by Darin in Nebraska on June 07, 2007 at 07:35:55:
here is the way i break in a fresh motor, everybody will have their own techniques. good lube is very important. fill an oil can with the recommended oil for your motor. put a couple squirts on each cylinder, also lube the rocker arms and squirt some around the valve springs so the valve stems have some initial lube. crank the motor with the plugs out, watch the oil pressure gauge till you start to get some pressure, that way you know the pump is primed. hook everything up an fire up the motor. i let em run at fast idle while i check every thing out. look for leaks ect. if everything is good, run the tractor around the yard, road, wherever of at least a half hour or so, vary the engine speed, dont go above 1/2 throttle. bring her back in the shed, retorque cylinder head if necessary, recheck everything, retighten all the hoses ect, check fluid levels, watch the oil pressure!!. if all is well a couple days of easy running will break it in.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|