Posted by Brad Buchanan on January 25, 2013 at 08:26:10 from (74.71.185.165):
In Reply to: Wind-chill question posted by Brad Buchanan on January 24, 2013 at 10:31:12:
Wow! Thanks for the great response.
Some fascinating theories. I will gladly defer to the more educated posters here as I must rely on my high school science classes in the distant past.
Anyway here is my two bit theory:
processes that produce heat are referred to as exothermic as they produce heat ie. fuel being burned in your tractors engine.
Processes that remove heat are referred to as endothermic ie. ice cubes melting in your hand crank ice cream maker or the 40mph wind cooling your tractor on the hill.
In the case of the two tractors the endothermic process continues until all the heat is removed from the machines. The tractor on the hill will indeed cool much faster but over the period of time both will cool to 0 degrees f.
Which will start more easily? Both engines being at the same temperature should start equally well but in my case if I was on the hill cranking the tractor the 40mph wind would blow my mad bomber hat off my head and It would take me 5 minutes to chase it down so....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.