Posted by Indiana Ken on January 24, 2013 at 17:50:03 from (66.249.232.131):
In Reply to: Wind-chill question posted by Brad Buchanan on January 24, 2013 at 10:31:12:
Quoting Removed, click Modern View to see
Okay I'll bite, to your question: You stated both tractors have been idle for a month however you did not state the temperature has been 0 degrees for a month:
Case 1, In the event the weather has been exactly 0 degrees for one month both tractors will be cold soaked to 0 degrees and there should be no difference in how they start.
Case 2, In the event your question assumes normal winter weather patterns where it warms up during the day and dips down at night the tractor exposed to the wind is more likely to be cold soaked to 0 degrees. The tractor in the barn is not exposed to the wind is more likely to be warmer. In this case the tractor in the barn is more likely to start or start more easily.
Why - the average temperature in winter over a 24 hour period will typically be much warmer than the 0 degrees which is likely a night time low. In other words there is more time at temperatures above 0 degrees than the time at or near 0 degrees. The tractor sitting outside in the 40 MPH wind will follow the temperature more closely due to the wind - this is called convective heat transfer. The tractor in the barn lacks the convective heat transfer and stabilizes at a more average temperature. As the temperature falls outside this tractor (metal temperature) will lag behind that of the outside air and the metal temperature of the outside tractor. (Sorry that got a little long)
Case 3, For Case 1) and Case 2) above I assumed the tractors were not "plugged in" since it was not stated. However, lets take the case where the tractors are both plugged in and the heaters are identical. In this case the tractor in the barn is more likely to start since there is no wind to carry away heat as the heater attempts to warm the engine block. Since the tractor is trying to keep warm similar to a human - the 40 MPH wind makes the tractor colder by reducing the effectiveness of the heater.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
