Posted by ericlb on January 19, 2013 at 07:37:51 from (70.41.96.39):
In Reply to: Re: grain bed hoist posted by ihman73 on January 18, 2013 at 21:56:45:
here the dangerous part, and this is from personal experience, a single hoist is mounted in the center of the bed as well as the truck frame weather its a front hoist or a scissors lift, a twin cylinder hoist has the cylinders mounted outside the trucks frame on each side, fairly stable, until a hose breaks, and they will break, eventually, when that happens the cylinder with the broken hose collapses, if the load is still partially on the bed at this time this will pull the truck over on its side, 100% of the time, the first time i saw this a man standing 10 feet from the truck was killed, when the truck landed on him, the second time i saw this the truck driver lost his arm which was thrown out the cab window and crushed under the truck cab when it landed on its side, ive heard of many other twin cylinder mishaps, but these 2 i saw, [ the truck was repairable in 1 of these], by comparison a single cylinder hoist is a little less stable but only requires a driver with some common sense to dump the truck on level ground, in case of a hose failure the cylinder collapses, straight down onto the truck, if its still loaded it may or may not bend the truck frame, and it will make the driver and anybody standing in the area need to change his pants, but they will still be alive, and the truck may still be fixable,, after all my years around dump trucks i would never have a twin cylinder setup,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
