Posted by oldtanker on January 17, 2013 at 15:13:14 from (66.228.255.239):
In Reply to: Question for WWII buffs posted by Fritz Maurer on January 15, 2013 at 19:54:04:
Our big problem in Astan is lack of enough boots on the ground. One young guy I know showed me on a map the area his division was covering. By all rights to cover that area they need about 3 1/2 to 4 division. And really the area isn't that big. To really cove all of Astan would require 20-25 divisions. The active duty Army is 10 divisions.
Active Divisions
1st Armored Division, Fort Bliss, Texas
1st Cavalry Division, Fort Hood, Texas
1st Infantry Division, Fort Riley, Kansas
2nd Infantry Division, Camp Casey, South Korea
3rd Infantry Division, Fort Stewart, Georgia
4th Infantry Division, Fort Carson, Colorado
10th Mountain Division, Fort Drum, New York
25th Infantry Division, Schofield Barracks, Hawaii
82nd Airborne Division, Fort Bragg, North Carolina
101st Airborne Division, Fort Campbell, Kentucky
Each Mech Infantry and Armor division is over 20,000 people but only about 8,000 are combat jobs, the rest are support. 8.000 men don't cover a very large area when you consider 24 hr ops and part of those guys are going to be refitting or on reaction force.
So now we have to relye on unreliable "allies" to contol the bulk of Astan.
So under current guidlines set by congress about the size of the military we can't win this one. It's not the hearts and minds of our service men and women, it's the lack of man power and unwillingness of the tax payer to fund a larger military while trying to get the national budget under control and pay the deficit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
