Posted by Hal/Eastern WA on January 13, 2013 at 16:20:38 from (97.115.189.199):
Anyone ever use a Water Leak Detector? They advertise that they can find leaks underground with special sound equipment. I was wondering if they were successful, and how much the service cost.
I believe that the galvanized 1" pipe that I buried from the pump house to the house about 37 years ago has started leaking, and pretty bad. Unfortunately the pipe is at least 5 feet under ground and about 100 feet long. The temperature is in the single digits at night and there is about a foot of snow on the ground.
This morning I got up early and dug out a hydrant that has given me trouble before. It was really hard work, with the first 8 inches of soil like concrete. After digging for a couple of hours, I did not find evidence of a leak around the hydrant. I was able to isolate the house from the pipe through the yard, by closing a valve, but the leaking continued. I tried listening to see if I could hear the leak, but I am fairly deaf.
Unfortunately the well I have is not a large producer, and yesterday I think we just about ran it dry, with the pump cycling over and over. Overnight, I shut the main valve in the pump house off, and the pump shut off and it held the pressure all night. So I am pretty sure that the pump, well and pressure tank are OK. But even with the valve that shuts off all the house water off, I can hear quite a bit of water moving when I open the main valve in the pump house.
It has to be a leak, and it must be a pretty substantial one. I keep hoping that water will come to the surface somewhere, or the snow will melt, so I will know where to dig. So far, there are no signs.
A friend of mine has a backhoe, and we probably COULD dig up the driveway area and put in a new line. But it is a lousy time to work on things outside. I would prefer to just fix the line where it is leaking, if possible, at least for now. I wish I knew exactly where it is!
Any experience with water leak detectors? Thanks, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
