Except the 7' your lift links are not long enough to let you swing the 7' blade around. Your tractor has the same lift arms as my 2N and the 7' will not rotate without taking it off, the 6' will and they will just clear the tires. The 7' I had for a 4100 series Ford (3 cylinder 4000 with 38" rear wheels and cat 2 lift and it would work good on it but it is just way too much blade for your tractor that is the approximatly same physical size as the 2N and the 601 is just a newer version of the NAA that I also had before the 4100 and you try putting a 7' blade on any of them and you will just have problems. Don't use the 7' any more, just keeping it because they are not worth enough to try to sell and as I have the cat 1 pins and it being able to be offset if I would decide I needed to I could bolt it to the ofset position and leave it up in air to just reach out and push off the top of the snow bank.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
