Clean and rinse the tank. Drill a 1.5 inch hole opposite the dent. Use rounded end steel rods, and hard wood sticks to pound out the dent through the hole. Pound into sand bags or soft earth and it will be easier to control the result. You can also put flat metal into the tank to push on with the previously mentioned rods. Once the dents are taken to your satisfaction, have a disk of metal welded back in the hole. Remember a used good tank is probably a reasonable alternative. If it were one of three tractors with that tank, investing time is a rewarding experience. Otherwise not. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 1952 Ferguson TO30 Restoration Story - by Mike Mc Andrews. I have been planning for many years to build a home and in preparation for this, I decided that I should have a tractor to prepare a driveway, do landscaping and haul material on my acre of land. I have a Cub Cadet for tilling and mowing but I decided that I needed something larger and with a loader. I enjoy repairing things and I like to save some money so I purchaced a 1952 Ferguson TO-30 with a Wagner loader.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
