Posted by RMinVa on January 07, 2013 at 17:31:21 from (67.142.166.26):
In Reply to: OT-Milk Wells posted by GarryinNC on January 07, 2013 at 14:38:45:
We used a spring here. Had to walk down about 25 ft. from the edge of the pasture and about 100 yards from the house. One way in and one way out. Banks are so steep can't walk on 3 sides of it. This spring still runs today. Kept milk,butter milk, watermelons and canteloupe in there. In the winter that's where I watered the mules about 30ft. below the spring. Every day before I went to school.
We didn't get power till 1948. My Dad had a new tractor after WWII(Army intelligence, south pacific 4.5 years) and he used it to pull the line down our highway. Most of it was pulled in by mules. Half the length of the road by my house was paved in 1951 and the other half in 1987. My Dad said he saw the main road being built (RT. 40) by prisoners with pics and shovels and ball and chains in 1931.
We had running water in the house in 1952 with a shower in the basement. Got the bathroom added in 1968. I was in the 4th grade before I saw an indoor bathroom.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
