Most of the auctions around here will announce more than once that everything is being sold "as is". At that point in time tools left in a baler are the buyers.
So now the question is would you keep them of give them back. 1st would be the sellers attitude. If he said "het I screwed up and forgot about those tools" I'd be inclined to let him have them. If he said "hey wait those tools were not part of the deal" and just started unloading them well then I'd just have to tell him to put em back and inform himthat if he refused I was going to have him charged with theft. 2nd consideration would be area. If in say within 10 miles of me, I'd keep the loacl peace and let him keep them. I live in the area too and these people are freinds. No hard feelings. But I attend auctions as much as 100 miles away. That far and the seller attitud would be the deciding factor. Now toss int the fact that they were Crapman tools I just wouldn't worry about em.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
