Posted by ralph wilton on December 31, 2012 at 07:37:57 from (64.127.82.36):
In Reply to: used oil heater posted by Ralphwd45 on December 30, 2012 at 19:58:54:
we got some plans off the net years ago to make a oil injecting nozzle you take a 1/4 copper line insert a large torch tip cleaner and smash it down then insert this in a 3/8 steel line so it almost sticking out the end intall a tee and have the oil run down the 3/8 steel pipe with a bal valve to control the flow then hook regulated shop air to the copper line run about 30psi of air in it this will ake like a fuel injector and atomize the oil we have heated our shop for 10 years this way cost 13 dollars to build and no filters to plug or anything to clean the barrel of oil is mounted behind the stove aways we use about 15 gallons a day when its real cold
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
