Posted by bill in colo on December 30, 2012 at 09:54:44 from (75.107.0.53):
In Reply to: Kinda OT Irrigation posted by super99 on December 30, 2012 at 06:08:23:
I have a Greenfield mini pivot from Zimmactic 660' with a end gun. When my pivot is on the low side end is only 10' above the water source when it is 180 degrees it is 90+ feet above water source, my 20hp pump puts out about 235gpm @ 100psi. I have tight soil so i run Nelson rotators regulated to 12psi. Some towers climb up to 20% which is at design limit for 90' spans,I have 4 90's and 3 100,s I've run this system for 13 years. My pumping costs were at 90 per ton this year driest year that the pivot been in use. I will buy a full sized system next time, I've been around pivots long enough now to buy a used system. About 50% of the new systems here are T&L oil drives as very few rancher here are good at trouble shooting electrics.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
