Posted by Roger tomfohrde on December 29, 2012 at 10:15:39 from (71.49.82.136):
In Reply to: OT: Furnace Problem posted by Buzzman72 on December 29, 2012 at 09:19:26:
Are you able to check to see if there is voltage going to the control board with a voltmeter? Should be 24V.This sounds like a either the board is junk or the power is not getting to it. Can you read the schematic to see where the internal fuses/safeties are if it has them? I worked on bard package units years ago but I had the wiring diagram to work from.I tried googling it and did not come up with one. A list of things ; Safeties, fuses, thermostat, transformer not getting power, tranformer not delivering power, loose wires, If it has the honeywell smart valve it could be the connections however that is after the controler I believe. Just trying to list some things to check.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
