Posted by Paul in MN on December 22, 2012 at 16:46:55 from (174.20.145.22):
In Reply to: Loader vs snow plow posted by JayinNY on December 22, 2012 at 16:25:49:
It depends on how much snow depth you need to plow and how big an area you need to clear.
I have found the FEL on any of our tractors to be way too slow, and once you have weight in the bucket, you lose rear wheel traction. And an 8N Dearborn FEL is the poorest of them all.
My preference is a front blade with power turn (hydraulic) which can be modified from an older PU system with the electro-lift. I prefer the Meyers, as it takes less power from the battery (12 volt neg ground only). And then hang a 3pt rear blade on the back of the tractor. The rear blade can be reversed to plow backwards and as the load against the blade gets heavy, pull up on the lift handle just a bit to give weight transfer to the rear wheels, and when you get to the stack, pull up the blade as high as it will go to get snow stacked about 6 ft deep. If you have huge drifts, use the rear blade in a herring bone pattern. Push further back than you think is needed. The pile gets hard like concrete very quickly as the after storm temps drop.
Been plowing snow commercially since '67, started with the 8N, and used it for quite a number of years until we got bigger equipment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
