Posted by Paul from MI on December 22, 2012 at 15:41:37 from (204.106.250.243):
I planned on going to the woods to load a couple of logs on my trailer to haul to the barn to cut up. Messed aroiund doing honey-dos, waited too long, frost melted and the top was greasy. Still I managed to get a few loaded without getting totally stuck. Headed for home about a 1/2 mile away, wasn't watching, ran over a limb and broke hydraulic pipe out of the loader cylinder. Fortunately there was enough oil left to tip the bucket and raise the loader about a foot so I could chain it up. got back to the barn, managed to get the broken piece out of the cylinder. But the threads are bit buggered up. I need a 1/2"NPT tap to straighten them. The local industrial supply is closed, may not be open Monday. Big box stores never heard of a pipe tap. There's a local hardware in a neighboring town of about 1,200. He was still open and had what I wanted at about 2/3 the cost of the industrial supply. I buy quite a bit of stuff there and he always seems to have what I need. Got to support those kind of people.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
