Posted by fixerupper on December 19, 2012 at 18:07:44 from (100.42.82.30):
In Reply to: Ripping with a JD 4430 posted by reid1650 on December 19, 2012 at 16:39:13:
In my neck of the woods in NWIA I used to pull a 5 shank Deere 910 ripper 10" deep with a 1086 running 150 HP at a shy 5 MPH but in my view it was brutal on the tractor. In the low heavy ground I'd be down to 3 MPH or even less. The 1086 was still a 135 horse tractor and that's what it was built for. I'd think a 4430 would be about the same. Today I pull that same ripper with a stock (I think) 4650 and it's a lot better match. It'll do 5.5-6 mPH in tough black ground at 12" deep and the tractor is stable as a rock. I've only had the front end up twice with only a medium sized rock box for front end weight.
Not saying you shouldn't pull 5 shanks with a 4430 but a ripper like mine is unforgiving and I just don't think a 135 horse tractor is generally built tough enough to take it in the long run. The harder the ground, the deeper that ripper wants to suck in. If the two 11Lx15 gauge wheels aren't pumped up to 45 psi they squish too much and the ripper will suck down more than you want it to. The lighter the ship you have in front of that anchor, the harder time you'll have controlling it. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
