Posted by da.bees on December 14, 2012 at 11:04:34 from (72.181.183.240):
In Reply to: Precision........... posted by gtractorfan on December 13, 2012 at 18:55:11:
Quoting Removed, click Modern View to see
Truer words never spoken. Seems like the norm is to scrape off grass,put up some string and form the foundation. 6 months later the owner notices water ponding around the building and starts spreading top soil around the building which soon has the slab level with surounding grade leaving no where to go as long as the building stands. Same applies to driveway construction.
Not to miniumize the value of experienced operators but my nephew shoots a site with equipment that alows him to put the information on his laptop which in turn is programed into onboard devices of dirt moving equipment as large or small the job requires as well as send plan to inspectors,engineers ect.Operator follows instruction on a screen as the site is prepared. As it stands,it is getting increasingly difficult for contractors to have thier bid considered unless they have a similar system because the people who work for the client (largly government) can't interpit manual plans or information. Nephew says they actualy don't understand either type information but they can e-mail this stuff around to enough different people that noone has to be responsiable for mistakes or overlooked issues.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.