Posted by JD Seller on December 10, 2012 at 07:40:36 from (208.126.196.144):
In Reply to: Concrete in December posted by G1050 on December 10, 2012 at 06:43:22:
I have poured concrete in the winter. It always turns out to be much harder to do and half the time you end up with a poor quality finish. I would not recommend doing it unless you have no other choice.
I poured two of my cattle floors in the winter. I had to hire it done because I did not have concrete blankets to cover it with. So that added to the cost. The contractor doing the work busted his butt fighting the cold. He covered it all and setup a tent with heaters the second day so they could work on the finish. He left the concrete covers on it for ten days after the pour. So I think he did all he could to make it work.
The second winter the finish coat started to flake off. I mean the top 1/2 inch or so. In big chunks that where some times larger than three feet in a spot. I had the contractor back out to look at it. He said that it had frozen even with the covers. That made the finish crack away from the base.
So I now have a eight inch thick cobble stone finish cattle yard. Every time I scrap manure I cuss myself for not waiting.
Also if you just leveled your building spot I would want it to settle down before I poured anything around it. The fact you have sand ground make that even more of an issue. The ground settles much slower. Did you compact the dirt in the fill or is it fresh cut with no back fill???
So unless you have to do it now I would wait until next spring to do the pour. It could turn out fine but if it does like mine and flakes off than you have the problem in your shop. If you just have to do something then just pour the footers and then do the floors next spring.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Little "M" - by Donnie Anderson. They call me "Little M" and this is my story. For the past several years I have sat against the tree-line, where my parts have rusted and rotted away. For all of these years I have wondered just exactly what happens to old tractors? Times were not always like this. I can remember back to 1948 when I was a brand new John Deere Model M. A man and his wife came to the dealer and looked me over real good. After many talks with the salesman a deal was struck and I, along with a M2 plow, c
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
