Posted by Bret4207 on December 10, 2012 at 04:07:00 from (64.19.90.196):
In Reply to: Marlin 35 remington posted by farmallray on December 09, 2012 at 09:38:44:
I own a 1952 336 Sporting Carbine. Excellent rifle and cartridge. I prefer to shoot cast from mine but the jacketed stuff works fine too. As with so many other older cartridges, it's limited more by trajectory than power. Certainly it's very good out to 150 or so yards with decent eyesight and open sights. Myself, I limit it some because my eyes are failing. A scope helps, but you still need to keep drop in mind. We have a lot of "hunters" around here with 12x or higher powered scopes that seem to think if they can see it they can shoot it. We also have a lot of fat coyotes that are far better at tracking gut shot deer than humans.
As with anything, shot placement is key. The 35 is a marvelous caliber in handguns and rifles. I've killed an awful lot of deer with a 357 Mag.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
