Posted by donjr on December 04, 2012 at 19:41:32 from (72.71.177.182):
In Reply to: yall ever watch posted by Bob Huntress on December 04, 2012 at 19:13:57:
I've never watched it, and don't plan to. However, my G-son (8) has told me all about it. Ya see, you only need a shotgun, a pistol and maylay (sp.?) tools. Everyone else will be underground and they're all dead. Then the scientists stuck a needle in the living folks, and they turn into zombies, and then the zombies bite the scientists and turn them into zombies. and when the zombies attack, you just shot their heads off until you run out of shotgun shells, then you shot them with the pistol until you run out of bullets and then you use the maylay tools to chop their heads off. I'm kinda glad now that the world is ending before Christmas. I won't have to go out hunting for maylay tools for him.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.