The usual shots in the dark have already been offered,let's try something systematic for a change. You didn't mention the volume or pressure changing so I assume they don't. Turn the shower on then feel the pipe as it exits the heater. If the pipe alternates between hot and cold,that eleminates everything down stream including the shower hot&cold controls. I don't know exactly how the heat pump is plumbed in but it probably would be playing a part in this eventhough it's plumbed correct. If the dip tube is broken inside the heater"AND"the pump is cycling about ever 3 minutes,that could cause the osulation in tempature. Set the heat so it does not cycle the repeat the test above. If the water runs hot then cold and stays cold,90% odds are the dip tube is broken off. If there is no effect,move to the shower facuet. Single handel controls are known to do crazy things. Rebuild or replace it. If you have dual knobs,there is a chance the problem can be solved by replacing both washers and/or cartridges. Still no joy??? Let's move to the laundry. Turn off either supply valve to washer and repeat test. If that stops the problem,replace the mixer valve on washin machine. We will stop here until you have gone through all that and repost. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
