Posted by JD Seller on November 24, 2012 at 17:41:00 from (208.126.196.144):
In Reply to: Clutch posted by Bruce Bushnell on November 24, 2012 at 17:17:39:
Why not just put a kit in the one you have??? All that usually goes wrong is the rubber cups wear/tear. There are an early and late reservoir but the kit is the same for both. It is #10 in the picture. Part # AL67034 it lists for $122.79. I have done many of them and never had an issue. Just hone the bore an clean it up real good then install the new plunger and boot.
Also the complete master cylinder is part# AL66874 that fits early and late serial numbers. The early subs to this number. Full list price is only $238.70 not $300. Don't know where you guys are getting these incorrect prices. Also one of the three local dealers has one complete in stock and all three have the rebuild kit. So common part here.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Piston Ring Removal and Replacement - by Chris Pratt. Piston Ring Removal and Replacement - Replacing rings is a fairly easy process to stretch the engines usability between major rebuilds and cut down on that blue smoke and high oil consumption. Frequently, replacing only the rings is not advisable because by the time you do the teardown and measurement of the components, the pistons are often beyond the manufacturers specification or something else you find will signify the need for a major rebu
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
