Posted by johnlobb on November 19, 2012 at 05:54:50 from (67.142.181.23):
In Reply to: Radiant Floor Heat posted by edj856 on November 18, 2012 at 19:04:12:
I was a vice president of the Michigan Radiant Panel Association, and represented Slant Fin in Michigan. Insulation on the edge of the slab and under the slab is essential. I heard some horror stories when no insulation was used in a radiant installation. One do-it-youselfer in the upper peninsula of Mich found out he was heating the world when the ground 3 feet all around his home never froze in the winter and he had $300 a month LP bills (12 yrs ago). There have been studies that have found up to 50% savings in the heat bill in certain instances. Look at the picture posted of the even heating, with scorched air, you are heating the ceiling and upper walls and losing many BTU"s that way. I see many of you have found out how excellent radiant heat is. There is no more comfy or frugal way to heat almost anything. More info is available at Dan Holohan"s website, heatinghelp.com. Dan has a book there available written for the layperson on radiant heat and other books on hot water and steam boilers and heating. This type of heat can be retrofitted to many structures as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.