Posted by farmallsandcoops on November 08, 2012 at 09:31:13 from (69.57.203.41):
In Reply to: Farm subsidies posted by Fritz Maurer on November 07, 2012 at 16:58:42:
The 80% figure is largely correct in terms of the percentage of the "farm bill" that nutrition programs make up.
Paul did forget the ACRE (Average Crop Revenue Election) program. Pays farmers if their revenue falls below a specified level, but to generate a payment it requires the revenue loss on both the farm and state level. Complicated program and few enrolled.
CRP is not a real small program -- $1.7 billion in payments annually. It was started as a land idling program and has become more environmentally oriented. And around 50% to 60% of those who have land in the CRP reenroll it when given the opportunity. However, the "average" rent on those acres currently is around $50 per acre. Program is biggest in wheat
In years passed, we HAVE paid folks not to farm. The PIK program in 1983 was one. ANd there used to be at times a set-aside program where to get other payments you had to idle a portion of your land.
Oh... and the Environmental Working Group is the group behind that farmer payment database. They merely put that together to build support for getting rid of farm subsidies... or at least retarget them to "small" farmers -- Sen. Pat Roberts (Kan.) always asks if someone says that if they are referring to the farmer that is 5 ft. 2 inches tall!!! Their little database includes things like commodity loans which farmers pay back. They find a lot of support among those who think big is bad. Guess those folks have never heard the term cowboy economics -- spread your costs over more acres. Pretty simple concept really.
And a chunk of those who are against subsidies to bigger farmers are that way because they couldn't get big themselves.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
