Posted by ericlb on November 02, 2012 at 06:08:17 from (12.189.32.37):
got a question, yesterday at sunrise it was pretty cold out maybe 30, i didnt look, but went to work did my safety checks and fired up our cat 325B excavator, warmed it up for probably 30 minutes,and climbed up on the high bank i was working on, everything worked as it should until, i went to dump the bucket, while it rotated to the closed position when it filled, like it should, when i went to open the bucket it would not rotate past about halfway, not enough to dump even with the dipper, and boom all the way up, i finally got it to dump by wiggling the control stalk just slightly, moving the control all the way to the right caused loss of control of the bucket, and it rotated almost closed by itself, hydraulic fluid is full, with about 30 hours on a full change and filters, any ideas? after about 2 hours it returned to normal operation by itself, that's kind of annoying to say the least and i don't really need the issue all winter
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
