I started out that way, studying pre-architecture at a jr. college. The math/science part transferred fine, BUT the architectural design classes at Lawrence Institute of Technology were sequenced, i.e. Design 101, 102 etc. None of the jr. college architecture courses fullfilled any of the design requirements. I had to start that series at the beginning. I got bummed out with profs that took roll and disapeared, taught on their lunch hour, etc. Final disillusion came when a student nearing his senior year gave us a plan where you had to cut diagonally through the living room to get to the stairs to the upper bedrooms. That's a no-no. Came back home and worked 40 years in the interior trades estimating jobs. Designed my own house with living in one wing, bedrooms in another. Kids could come home from dates and go to bed and we wouldn't even see them unless we wanted to.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.