Posted by Ralphwd45 on October 30, 2012 at 17:05:36 from (66.243.226.232):
I saw the post by Dave2 about using his torch set up to weld with. didn't want to highjack his post, but did want to comment! Several yr's ago I bought one of Harbor Freight's portable band saws, and have used it extensively to fabricate metal with. I have a chop saw, but rarely use it, as blades don;t last long, and I have to watch out for sparks igniting old rags, that I never knew they were there. Grease rags are that way, they are not to be found when you need them, and right in harms way when you least expect it.The blades and repair parts for the porta-band's are redily available from HF. They are so cheap at HF, that if I needed another one,then I will just run to the store and pick up a new one. Milwalkie makes a deep cut porta band, but my HF porta band has lasted for 5 yrs, and has had a wheel replaced, once. I have been using propane for many yr's to weld, cut, and braze with. I seem to use more oxygen, with propane, and have had to use the 2 piece cutting tips, made for propane, but the local gas station will refill my bottle even on sundays. I suppose that they may have special welding tips for propane, simular to the cutting tips, but have never needed to ask. I just use a larger aceteline welding tip.Now oxygen is another story! It always runs out on the week ends, and NAPA wont exchange cyl's with me, due to the company that I bought the bottle at, isn't part of their group. Pacific welding, is closed on the weekends, and I have to wait till Monday to get oxygen. Luckily I don;t use my torch that much, but when I do need it, nothing else can replace it. Heat rusted bolts and nuts, heat king pins, to remove them, and just about would have my hands tied without it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
