Posted by tedregentin on October 25, 2012 at 20:12:20 from (216.110.201.79):
Go ahead and laugh, I deserve it. A regular customer brought in a 66 Vette not running right. Ordinarily, I try to stay away from classics, custom, and speciality cars, for we normally are running about a week out for appointments. Some one else can have the glory and the headaches. The vette quickly quickly progressed from running rough to not starting at all. So I had to leave it in the shop so we didn't have to push it in at night. Yesterday I took a look at it and couldn't find any reason why it wouldn't run. I checked all the basics, and everything looked good. I went in early today, figuring I needed some quiet time to find the problem. I decided that it just had to be old gas causing the no start. So I hooked up a battery charger, the battery is just behind the drivers front wheel. I took off the air cleaner, propped the choke open with a screwdriver, opened the drivers door, reached in with my right foot to floor board the accelerator pedal. worked the key with my right hand, and sprayed some ether while cranking. Unbeknownst to me the local trans shop decided that the neutral safety switch wasn't necessary and bypassed it. The car started and immediately started to move forward. At the same time, the engine backfired and caught the ether on fire. I got the car shut off, blew out the fire and then looked at the damage. Wasn't too bad, the drivers door hit the battery charger. The body shop looked at the door and said that they would have to sand the door down and repaint it. It could have been much, much worse. I've been working in this business for almost thirty eight years now, and I can't say that something like this has ever happened before. Just go ahead, have a laugh on me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.