Posted by wisbaker on October 25, 2012 at 13:23:02 from (207.118.181.192):
In Reply to: O/T Sears boots posted by 37Chief on October 25, 2012 at 08:54:51:
I remember looking for a pair of work boots 30 + years ago, like you I wanted flat soles. At that time the only place I could find them was Red Wing but as a broke college student I couldn't afford the tariff and Red Wings had a real high arch support that didn't match my flat feet so lived with the lugs even though they were hard on the greens. After joining the Air Force I found some issue boots had a less aggressive sole. Over the years I have found some Rocky's that had a vibram sole, but then work issued a steel toe mandate and this boot wasn't available in steel toe. Rendering plants are heck on boots so I started getting cheaper boots 'cause they'd only last about 6-8 months. Some of the Duty boots folks in Kentucky like Gall's or US Cavalry sell can be bought in a finer sole but usually only come in black. After starting for the county I switched to black steel toed boots or oxfords they usually didn't have big lugs on them. So Red wings or Duty boots from a Military or Cop Shop supplier.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
