Posted by JDseller on October 19, 2012 at 18:45:34 from (208.126.196.144):
In Reply to: Baling corn stalks posted by samn40 on October 19, 2012 at 13:15:56:
samn40: I posted the picture above to show you The finished product of baling corn stalks. We usually bale 2500-3000 for our own use. We also do 13-15K as custom baling for others.
I have a Haybuster 2564 bale buster. I just load the bales and blow the stalks into the cattle sheds. The bale processor will just chew up the mesh wrap and you don't have to remove it. You rarely find any in the manure big enough to cause any problems.
I have attached a video of a Haybuster baler processor working.
The few corn stalks bales we feed are usually tub ground with grass hay just for fiber in a finish beef feed ration.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Piston Ring Removal and Replacement - by Chris Pratt. Piston Ring Removal and Replacement - Replacing rings is a fairly easy process to stretch the engines usability between major rebuilds and cut down on that blue smoke and high oil consumption. Frequently, replacing only the rings is not advisable because by the time you do the teardown and measurement of the components, the pistons are often beyond the manufacturers specification or something else you find will signify the need for a major rebu
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
