Posted by NCWayne on October 18, 2012 at 23:48:19 from (69.40.232.132):
I haven't figured out how to get the videos off my phone of the bale buster in operation so I can post them, but it has been up and running now for about three weeks. There was a bit of a learning curve for the operator, as well as tuning up on the machine itself getting speeds set, etc, but that's pretty much behind us now. As it stands now they are currently able to bust, on average, 6 big bales and hour which equates out to around 180 small bales (((about 30 small bales per big bale))). So far they can load two 53 foot trailers in a day, and managed to get 2 and a half on one good day.
As it stands they are having to all but stop the machine for every bale to cut the strings, which takes up a minute or two each time. Seems I designed it around a 4x4x8 bale, what I was told, and the bales are actually closer to 51"x51"x8'6" plus feet. In other words there's not enough room left in the 8'6" I left for them to cut the strings to actually do it the way we had planned. I'm waiting on material now to build a prep table, something we had planned from the start anyways, that will allow them to keep the bale that's on feed going while getting another ready to feed,and room for a third bale when the first one in line gets about half way through.
So, if they can get things worked out with the new setup, that will allow them to get in the neighborhood of 210 to 240 bales an hour. Based on what I've read that's pretty consistent with what can be done in the field under ideal conditions. Thing is this is all under a shed so the big bales can be picked up and brought in alot faster, with less equioment, less labor and therefore less cost involved. Once in the barn, then they can, as my customer and I were discussing today, "Make hay, even when the sun ain't shining'...and that's a good thing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
